Bilateral ESP32 insole system measuring plantar pressure distribution in real time. Senior capstone, and a finalist for the IEEE EMBS Boston Chapter 2026 Senior Capstone Award.
WHAT I BUILT
Designed PCB V2 in KiCad: 8 pressure sensors, two MCP6004 op-amps and a XIAO ESP32-S3 on a 45 by 30 mm board, fabricated through JLCPCB.
Wrote firmware with ESP-NOW bilateral communication, CRC-16 packet validation, a hardware watchdog, OTA updates and CSV export served over a captive portal.
Characterized the sensors on an Instron load frame, fitting power-law response curves at R² of 0.998 and 0.992 for the A401 and A301.
Applied ISO 14971 risk management and incorporated input from two licensed physical therapists.
Documented the design and results in a 41-page engineering report.
TECH STACK
ESP32-S3C++KiCadESP-NOWMCP6004InstronISO 14971
PHOTOS
Presenting StepArc with the insole prototype.Live pressure dashboard running next to the insoles and the poster.Insole prototypes and the board on the demo table.Printed insole shells with the sensor pockets.Treadmill walking test.Live pressure dashboard: individual sensors, zone view, heat map and sensor data.Single sensor test on the heel center sensor.CAD section view of the insole.System flow: the right insole collects both feet and serves the live view over its own Wi-Fi hotspot.Firmware flow for the left insole board.Decision engine: a 3-point contact pattern mapped to an activity by a rule table.Concept render: sensor layout and board position on the insole.Concept render: the insole board.Concept render: insole shell from six angles.