← BACK TO PROJECTS
IN PROGRESSSpring 2024 - Present
Data AcquisitionTelemetryRacing

SAE Baja DAQ and Telemetry

Dual-ESP32 data acquisition and pit telemetry system for the Wentworth SAE Baja Leopard Racing team. Ran at the Palmyra, New York endurance competition.

WHAT I BUILT
  • Lead a 4-person electrical team covering data acquisition, telemetry and power distribution.
  • Built a dual-ESP32 architecture: a logging unit and an access point unit serving a three-tab pit dashboard over WiFi.
  • Defined a checksummed UART protocol carrying speed at 10 Hz and fuel flow at 1 Hz between the two units.
  • Clamped every sensor input with Zener protection and dividers after field failures.
  • Captured a 2.97 g impact event and a 19.4 mph peak at Palmyra, where the team placed 75th of 120 plus entries.
  • Traced a Hall sensor overcounting by 3.7 times to interrupt noise and fixed it with a 2000 microsecond debounce.
TECH STACK
ESP32C++UARTWiFi APSD LoggingNextionChart.js
PHOTOS
Car 200 on the test lot.
Car 200 on the test lot.
Driver display mounted in the car.
Driver display mounted in the car.
Driver display showing fuel flow, speed, battery and g-force.
Driver display showing fuel flow, speed, battery and g-force.
Hall sensor reading the toothed wheel for speed.
Hall sensor reading the toothed wheel for speed.
Bench test with the display layout on the laptop and the pit dashboard on a phone.
Bench test with the display layout on the laptop and the pit dashboard on a phone.
Wiring inside the electronics enclosure during a light test.
Wiring inside the electronics enclosure during a light test.
Firmware and wiring work at the shop bench.
Firmware and wiring work at the shop bench.
Car 200 at competition with the design posters.
Car 200 at competition with the design posters.
The Leopard Racing team with Car 200 in the shop.
The Leopard Racing team with Car 200 in the shop.
The team in the trailer with the car.
The team in the trailer with the car.